If required specific Unconditional modes can be set for a specific transport in TE.

By default these will be taken from the target system settings in the Windows GUI configuration, however these can be overridden at an individual transport level in both the SAP GUI and Windows GUI via the Advanced Options tab on the required transport form:

SAP GUI

Windows GUI

If the Unconditional modes have been changed for a transport form when this is viewed in TE Windows GUI the transport number will be highlighted in bold:

Feedback

Was this helpful?

Yes No
You indicated this topic was not helpful to you ...
Could you please leave a comment telling us why? Thank you!
Thanks for your feedback.

Post your comment on this topic.

Post Comment