Setting Auto-Drain/Dose Operation

Once Auto-Drain or Auto-Dose is enabled, the user can adjust Auto-Drain/Dose Configuration settings. To access the settings, press the PAGE ARROW from the Auto-Temperature Configuration screen.

!Ensure the drain hose is connected to a proper waste disposal reservoir before enabling Auto-Drain

Auto-Drain/Dose Configuration Settings

Number of Cycle Between Auto-Drain – Set the desired number of autocycles that must run before Auto-Draining occurs.

Auto-Level Check Wait Time – Sets the time between level checks during an autocycle while Auto-Level is enabled. After completion of an auto cycle, this is the amount of time that the systems waits before evaluating tank level. If below the configurable setting the system will automatically dose to 100%.

*Press the orange ⓧ button to exit any screen. A confirmation will display.