Auto Run Mode

Once the desired settings have been selected, the BASE is ready for the cycle to be initiated. To start, press the PLAY button .

*If there is a question mark displayed next to the PLAY button it is an indication that there is a condition inhibiting the cycle from starting.
For more information, press the green QUESTION MARK for more information.

Auto Run Screen

	PRESSURE GAUGE Displays the current pressure of the spray valves in operation.
	TEMPERATURE Displays the current temperature of the detergent in the tank.
	CLOCK Displays the remaining time in the cycle.

!The BASE is designed to detect conditions at the start of an Auto Run cycle that may inhibit performance or safety. See the Alarms and Warning section for full detail.

The Drain and Dose screen may appear prior to the cycle starting.
In this warning state, the user has the option to take corrective action (DRAIN or DOSE) or proceed as is. To acknowledge the warning and proceed, press CONTINUE.
At this time, detergent can be added to the tank.

Drain and Dose Screen

Prior to a cycle starting, users may see a Temperature wait screen as the machine is getting up to temp. Once the minimum temperature is reached, you are able to begin the cycle, which may impact total process time if it reaches the desired temp sooner than expected. Otherwise, letting the solution heat up to its set temperature fully, will allow the cycle to begin automatically.