Module Hardware /

EtherCAT Ports

! Failure to use SHIELDED cables may result in data loss and unexpected results

Both ports are standard RJ-45 jacks conforming to standard EtherCAT connection pin-out. In order to maintain IP54 rating; the EtherCAT cables need to be equipped with protective shrouds. Shown below are the EtherCAT cables installed using shrouds to protect the RJ-45 connectors on the cables. Each module is shipped with 3 shrouds – 2 for the EtherCAT Cables and 1 for the power wiring.

*Even though the images depict Pulseroller ConveyLinx-Ai2 modules, both the MotionLinx-Ai and MotionLinx-IO modules utilize the exact same protective shrouds and covers

How to install shrouds on EtherCAT cables

Assembly Tool

Phoenix Contact Part Number 2891547 FL IP 54 or SS TOOL-MET 621-80008

*Tool must be purchased separately

Putting the shroud on the cable

① With tool closed, place shroud on the pins		② Grip the handle to open the pins to stretch open the shroud
③ While continuing to grip the handle, insert the RJ-45 cable through the shroud opening as shown		④ Release the handle and the pins close allowing them to be removed from the shroud