Depending on installation, users may wish to temporarily (or permanently) disable the ATevo ground detect feature. If so:

  1. Shut down ATevo, and allow internal voltages to dissipate.
  2. Open the ATevo front panel door, and remove the safety shield.
  3. Locate the Power Board (A2).
  4. Identify the 3-pin shorting block (JP102), marked ‘GROUND DETECT’ on A2.
  5. Move the 2-pin jumper from the ENABLED to DISABLED position.
  6. Restart ATevo with ground detection disabled.

Last modified: 3 August 2023

¿Necesitas más ayuda?
No dudes en ponerte en contacto con nosotros aquí.

Gracias por darnos tu opinión.