These switches are used to select the acceleration and deceleration G force the control uses when starting and stopping the motor respectively. The EZ-Qube acceleration/deceleration control is designed to provide a constant G force or ramp slope regardless of the speed setting for a given SPEED DIP switch setting. The selections made on the ACC/DEC DIP switches set both the acceleration and deceleration G force to the same value when CONFIG DIP Switch 8 is OFF. When CONFIG DIP Switch 8 is ON, the deceleration value is 2X the acceleration value.

Settings for Equal Accel/Decel Ramps (CONFIG DIP Switch 8 = OFF)
Settings for Decel Ramp Equal 2 X Accel Ramp (CONFIG DIP Switch 8 = ON)