When the SETTINGS button is pressed, the user has access to basic operational functions as described below.
 |
| Enabling Settings |
*When a toggle button is enabled, a representative symbol will be displayed in the bottom right corner. 
Auto-Temperature – Heat is an important component of post-processing. The VORSA 500 has functionality built-in to allow the detergent to be maintained at a certain temperature when the machine is not in use. The AUTO-TEMPERATURE setting should be enabled if the tank needs to be kept at a constant temperature between cycles. If AUTO-TEMPERATURE is not enabled, the VORSA 500 tank heater will need to be run manually to bring the temperature up to the desired level before starting the cycle.
Auto-Level – When enabled, the tank level will be monitored at a user-defined interval. If the tank level drops below a predefined level the tank will be automatically dosed back to 100%. A message will appear to inform the user.
Advanced Output – When enabled, additional sensor data will be displayed in red throughout various screens. This mode is used for debugging.
Light Stack Test – 
When pressed and held, all three colors on the light stack should illuminate so the user can verify that the lights are operational, The light stack should be tested at the beginning of each shift. If any of the light colors do not illuminate, contact PostProcess for service.
Post your comment on this topic.