With the Transport Expresso client and server software installed, you are ready to begin configuring Transport Expresso, which can be done via the Windows client software. When you start the Windows client software, choose the SAP Logon system entry for the SAP system that you want to act as the Transport Expresso domain controller and then your logon details for that SAP system.

The first time that you start Transport Expresso after installing or upgrading, you may be asked to:

  • Run the ABAP program /BTI/TE_RCRUN in the Transport Expresso domain controller. This may be required to perform necessary internal initialisation and conversion steps. If the client software does not ask you to run this program then this step is not necessary.
  • Enter a license key for the Transport Expresso domain controller. The license key is determined using the system ID and installation number of the SAP system acting as the Transport Expresso domain controller. A license key is not required for the other participating SAP systems, or for the individual installations of the client software. Please contact Basis Technologies with these details (as shown by the client software) if you need a license key.

The Transport Expresso configuration can only be changed by a designated TE Administrator. The first person to logon to Transport Expresso following its installation is automatically defined as an administrator. The list of administrators can be changed afterwards if necessary.

Please refer to the following section “Configuring Transport Expresso” for further details.


Was this helpful?

Yes No
You indicated this topic was not helpful to you ...
Could you please leave a comment telling us why? Thank you!
Thanks for your feedback.

Post your comment on this topic.

Post Comment