Disallowed and Critical Objects Check can be used to check if Transports contain particular objects.

This Analyser is essentially the same as the TE Risk Guard analysis, but since it is possible to have both Analysers running in the same control point, you can set the Disallowed and Critical Objects Check analyser to not allow ‘Approve Anyway’ but set the standard Risk Guard to allow ‘Approve Anyway’.


MINIMUMRISKLEVEL: Minimum Risk Level from table/BTI/TE_RISKL
RISKGROUP: Risk Group from table /BTI/TE_RISKG


Was this helpful?

Yes No
You indicated this topic was not helpful to you ...
Could you please leave a comment telling us why? Thank you!
Thanks for your feedback.

Post your comment on this topic.

Post Comment