Pulseroller Products / Pulse Gear Drive (PGD) 24V/48V / General Specifications /
Washdown
General Specifications
| Washdown PGD-Ai | |
| Shaft Diameter | 16 mm |
| Keyway | 5 × 5 × 25 mm |
| Motor Cable Length | 1000 mm |
| Motor Controller Connection | 4 Pin M8 |
| Housing Material | Stainless Steel – SUS304 |
| Bearings & Shaft Materials | Stainless Steel – SUS303 |
| Ingress Protection | IP66 |
| O-Rings & Seals Material | Nitrile |
| Mechanical Brake Option | No |
| Ambient Temperature | -10 ~ 40º C (14 ~ 104º F) |
| Ambient Humidity | 10 ~ 90 RH (No Condensation) |
| Certifications | CE, UKCA, RoHS, IP54 UL Recognized to UL 1004-1 ETL Listed to UL 1004-1 & UL 1004-6 |
| Input Voltage | 24 VDC |
| Nominal Power Output | 40W (50W in BOOST Mode) |
| Rated Current | 2.5A (3.5A in BOOST Mode) |
| Starting Current | 5A BOOST Mode / 8A BOOST-8 Mode |
| Maximum Motor RPM | 5800 ECO / 4200 BOOST & BOOST-8 |
| Minimum Motor RPM | 580 |
| Minimum Duty Cycle | 0.5 sec ON / 0.5 sec OFF (1.5 sec OFF when in BOOST-8 Mode) |
| Continuous Operation | At rated load/current in ECO Mode |
| Compatible Controls | ConveyLinx-Ai2 ConveyLinx-Ai3-24-FC ConveyLinx-Ai3-24-RC MotionLinx-Ai E-QUBE-Ai EZ-QUBE-W-Ai |