Pulseroller Products / Motor Rollers / Ordering Information /

Senergy/Senergy-Ai 24V/48V


P R  A  D  4 8   5 0 0   4 5   Z   S   G   Q 
PULSEROLLER
Family
Model DC Roller Diameter Roller Length Speed Code Motor
Type
Shaft &
Custom
Options
Material & Lagging Options Interlock Options
Model
 A  – Standard  B  – Built-in Brake
 D  – Dual Drive  V NSF Certified Washdown (IP66 w/ NBR seals)
 W  – Washdown (IP66 w/ NBR seals)  Q  – Enhanced Washdown (IP69K w/ Viton seals)
 Z  – Freezer Rated
Roller Diameter
 48  – 48.6 mm (1.9”)  60  – 60.5 mm (2.38”)
 50  – 50 mm (1.97”)
Roller Length (mm) – Available in 1 mm increments
Formulas for Roller Length (RL) based upon Between Frame (BF) dimension for proper clearance
For Interlocking Options  A  and  G  : RL = BF – 8 mm – Customer Required Clearance
For Interlocking Options  H  and  F : RL = BF – 35 mm – Customer Required Clearance
For most conveyor applications, Customer Required Clearance = 2 mm
Speed Code
Select Speed Code from the selected Model’s specific Performance Charts
Tube Materials and Lagging Options
 Z  – Steel, Zinc Plating, No Lagging (Standard for Roller Diameters  48  and  50 )
 A  – Steel Unichrome Plating, No Lagging (Standard for Roller Diameter  60 )
 A  – Stainless Tube (Standard for Models  V  ,  W  and  Q )
 J  – Stainless Tube (Option for Models  A  ,  D  ,  B  and  Z )
 B  – 3mm Black Rubber Lagging
 W  – ⅛ in. (3.18 mm) Urethane Lagging  Q  – 2 mm Grey PVC Sleeve
 K  – ⅛ in. (3.18 mm) Kastalon Orange Sleeve  Y  – Special
Motor Type
 S  – Senergy (24V JST Connector)  M  – Senergy-Ai (24V 4-Pin M8 Connector)
 X  – Senergy-Ai-48 (48V 4-Pin M8 Connector)
Interlocking Options
 A  – Plain Straight (No Interlocking)  G  – Round Grooves
 H  – Micro-V Pulley  F  – Round Groove Pulley
 Y  – Special
Shaft &/or Custom Options (Motor End / Idler End)
 Q  – Non-Threaded Hex / Spring Loaded Hex  B  – Double Bearing Pinned Construction
 P  – M12 Threaded Hex / Spring Loaded Hex  Y  – Special