ConveyLinx-ECO Module status is indicated by several LED’s. All LED’s with the exception of the Ethernet Link and Activity LEDs are multi-colored and context sensitive. The following sections indicate the various meanings of all LED indicators.
If you need help finding where LED Items are located on the ConveyLinx-ECO Module
Communications
| Indicator | Item | LED State | Description |
|---|---|---|---|
| Link Left & Right |  &  |
OFF | No connection established |
| Solid Green | Connection is established | ||
| Blinking Green | When data transmission activity is occurring |
Motors
| Indicator | Item | LED State | Description |
|---|---|---|---|
| Motor Left & Right |  &  |
OFF | Motor is not running and no faults detected |
| Solid Green | Motor is running | ||
| Solid Red | If Motor is running – indicates current limit If Motor is stopped – indicates motor is not connected properly or is overheated Power supply is under 18V or above 30V |
||
| Blinking Red | Motor is overloaded and the module is limiting current to reduce temperature | ||
| Flashing Red | Motor short circuit detected between at least two of the phase windings or Motor Power supply is less than 10V | ||
| Solid Amber | Module is booting up | ||
| Slow Blinking Red | Profinet enabled discover function initiated from PLC |
Module Status
| Indicator | Item | LED State | Description |
|---|---|---|---|
| Module Status |  |
Blinking Red | Module is starting task processes |
| Blinking Green | Module is ready | ||
| Flashing Green & Blinking Red | Failsafe Mode | ||
| Flashing Red | Auto Configure Mode is active | ||
| Blinking Amber | Connection to peer lost or performing firmware upgrade check | ||
| Solid Amber | Firmware upgrade in progress | ||
| Slow Blinking Red | Replacement procedure time-out in progress |
Sensor Indicators
| Indicator | Item | LED State | Description |
|---|---|---|---|
| Sensors Left & Right |  &  |
Solid Green | Sensor Input is energized |
| Solid Amber | Module is booting up | ||
| Flashing Green | When in ZPA Mode and when Sensor is blocked – indicates external device (PLC/PC controller or EasyRoll) has accumulated the zone and inhibiting release | ||
| Blinking Red | Arrival Jam or missing sensor | ||
| Blinking Green/Amber | Sensor Jam | ||
| Flashing Amber | Power supply is less than 10V | ||
| Slow Blinking Red | Profinet enabled discover function initiated from PLC |
Aux Input Indicators
| Indicator | Item | LED State | Description |
|---|---|---|---|
| Aux Left & Right |  &  |
Solid Amber | Module is booting up |
| Solid Red | Local Aux Input energized | ||
| Flashing Amber | Power Supply is less than 10V | ||
| Slow Blinking Red | Profinet enabled discover function initiated from PLC |
Special Cases
| Indicator | Item | LED State | Description |
|---|---|---|---|
| All Sensors & Motors | |
Flashing Red | Module in stopped state |
| Left Sensor & Left Motor | |
Flashing Green | ZPA zone on left side of module is in Maintenance Mode* |
| Right Sensor & Right Motor | |
Flashing Green | ZPA zone on right side of module is in Maintenance Mode* |
Post your comment on this topic.