Draining the LEVO

The sediment tank is located on the floor in the center of the enclosure and collects the waste solution that has drained from the processing chamber.
Depending on the Drain Mode option selected in the Settings section, one of the following screens will be shown when the sediment tank has reached capacity.

*The sediment tank level sensor starts reading the tank level at 50%. As the tank fills, it may show 0% until it reaches the 50% threshold.

Drain Plumbed

If Drain Plumbed Mode is selected, the sediment tank pump will automatically turn on without disrupting the cycle.
The SEDIMENT PUMP button will turn blue to indicate that it is actively draining.

Drain Plumbed, Active sediment pump

!Draining the sediment tank in Plumbed Drain mode should only be done if the waste collection system can be filled without risk of overflow.

Bucket Drain

If Bucket Drain Mode is selected, the cycle will automatically pause and the user will be prompted to drain the sediment tank as shown below.
To drain, press and hold the BLUE ARROW. When the sediment tank is empty, the motor will resume the finishing process with no loss in finishing time.
This is also confirmed when the vertical green bar disappears, or the Sediment Tank % displays 0% on the Auto Run Mode screen.

Drain Bucket, User Prompt

!Ensure that the bucket or receptacle does not overflow while draining the sediment tank in Bucket Drain mode.