The LEVO is delivered with an industrial power cord. Use only the power cord supplied by PostProcess with the LEVO. Based on the model number of the machine, connect the LEVO only to the power indicated in the table below.
| SF001 | UL/CSA North America |
|---|---|
| MODEL | -03 |
| PHASE | 1 |
| VOLTAGE | 120VAC |
| FREQUENCY | 60 Hz |
| AMPERAGE | 15A |
Do not place the power cord in a location where it could come into contact with water or other liquid substances. It is recommended to keep the entire power cord suspended above the floor surface.
The LEVO utilizes power provided through an industrial power cable/connector located on the lower-left rear of the unit as highlighted in green below.
 |
| Power cord location length of cord trimmed to fit image |
The MASTER DISCONNECT SWITCH is located on the right access panel of the LEVO. Before connecting or disconnecting the LEVO to power, ensure the MASTER DISCONNECT SWITCH is in the horizontal “O” or OFF position.
When the power cord is connected to the LEVO and plugged into a specified power outlet, turn the POWER switch 90 degrees clockwise to the vertical “I” or ON position. The LEVO is now ready to be powered up.
 |
 |
 |
The MASTER DISCONNECT SWITCH is located on the right access panel, shown above. To turn OFF the MASTER DISCONNECT SWITCH, grasp the switch and rotate counter-clockwise 90˚ to OFF. |
Post your comment on this topic.