Adding Detergent and Media to the LEVO

Wear Protective Gloves
Wear Appropriate Eye Protection

Adding Detergent

!Although the hinged lid is designed to stay open while loading and unloading from the processing chamber, excessive vibration and other factors can cause it to close. Caution should be used when reaching into the processing chamber.

The LEVO has an 18.9 liter gallon (5 gallon) Supply Tank located under the Main Lid and to the left of the processing chamber. This tank holds a concentrate of PostProcess detergent that will automatically be mixed with a continuous water supply to be dispersed by the chamber nozzle. The ratio of detergent to water is between 1%-5% and is set by PostProcess based on the application.

To fill the Supply Tank, raise the Main Lid, remove the circular Supply Tank Cap (see image below, highlighted in green) and pour in the concentrate until the tank is full (approximately 2.5 cm, or 1 in) from the top. Replace the Supply Tank Cap and close the Main Lid. The Supply Tank % can be viewed within the AUTOMAT3D or MANUAL run screens. See Automatic Operation – Setup/Start for more information.

!A continuous water supply must be connected to the LEVO to start a cycle.
A Low Pressure Alarm will display if the proper water supply is not detected.

Top View, Lid Removed, Supply Tank Cap Highlighted

*When filling from empty, the Supply Tank must be refilled to at least 50% for the level sensor to detect new detergent. If not refilled to 50%, the user will not be able to start a cycle.

Adding Media

To add media, raise the lid and pour media from the storage container directly into the processing chamber (see image below, highlighted in green) until it is approximately half way full.

Top View, Lid Removed, Processing Chamber Highlighted

!Only PostProcess approved consumables should be used in the LEVO. Using third party consumables may void the warranty on the machine.
Safety Data Sheets will be provided for all purchased consumables.