Create items, BOM’s and routings in BC/NAV
When the CadConnect work is finished, the last job step is to create data in BC/NAV.
The is done by clicking the “Create items, BOM and Routing” box at the ribbon.
You will be notified by the following message. The meaning of this is to say that any changes made beneath level 1 items, will not be performed.
Next message is a check if you should have forgot to actualize the cost calculation, you have the opportunity now to recalculate.
Next message you must decide what kind of bill of materials you want to create – Production BOM or Assembly BOM or both. Note. This message box is controlled by the CadConnect setup, and only shown if you have selected “both” as BOM type for creation.
Next message if you want to update an existing routing:
And finally when the creation process has finished you will get this notice.
Hinterlasse einen Kommentar.