You must install and remove the Blast sensor correctly.

**How to place your sensor into the attachment and then onto the bat. **

1 Turn the Bat Attachment inside out.
2 Take your sensor and place it on the top of the Attachment. Make sure the Blast Motion Logo is facing down toward the Attachment.
3 Reverse the Attachment from the inside out so that the sensor is now inside the Attachment. Ensure the logo is showing on top inside.
4 Place the Attachment on the Knob of the bat. Ensure the sensor is secured on the bat.

Need more help with this?
Support Page

Was this helpful?

Yes No
You indicated this topic was not helpful to you ...
Could you please leave a comment telling us why? Thank you!
Thanks for your feedback.