!Important: The configuration can be changed in SmartView while the SmartMonitor device is running and may not yet have been delivered to the device. This may impact the alarm status displayed on the device.
| Air Pressure |
- Excess pressure or vacuum can damage the device.
|
| Attention |
- The SmartMonitor measures the ambient temperature and not the quality of the monitored goods. Its purpose is to signal if product quality evaluation is required.
|
| Battery |
- The battery cannot be removed or replaced. Check the technical specification for detailed battery information. Contact Berlinger support at support@berlinger.com for refurbishment options.
- Risk of fire or explosion if the battery is replaced by an incorrect type.
- Risk of explosion if the battery is disposed of in a fire or hot oven.
- Leaving the battery in an extremely high temperature surrounding environment can result in an explosion or leakage.
- Do not subject battery to extremely low air pressure that may result in an explosion or the leakage of flammable liquid or gas.
- Instructions required by IEC 62368-1 regarding coin cells.
|
| Compatibility |
- SmartMonitor device only works in combination with the SmartView software (version 6.0 or higher).
|
| Damage |
- If the SmartMonitor device is damaged, don’t use it and contact Berlinger support for refurbishment options.
|
| General |
- Ensure that the user manual instructions are followed before using the SmartMonitor for monitoring. Without proper starting, the measurements will not be available.
|
| Ingress Protection |
- IP65: Protect from dust ingress and water spray from any direction.
|
| Liability |
The manufacturer shall not be held liable.
- if the device was used beyond the manufacturer’s given limitations.
- for any claims due to improper storage or use of the device.
- for any problems with the temperature-controlling and/or -cooling unit.
- for the quality of any monitored goods.
- for incorrect readings if the device was used beyond its expiry date.
|
| Mechanical force |
- Avoid violent shocks and impacts.
|
| Microwave |
- Do not expose the device to microwave radiation (risk of battery explosion).
|
| Multifunctional button |
- Do not apply force as it will damage the button.
|
| Recycling |
- Recycle the product at the end of its lifetime according to local regulations.
|
| Safety |
- Keep away from children.
- Don’t open it.
- Berlinger recommends training of all persons that handle the SmartMonitor device and/or SmartView.
|
| USB plug |
- The USB plug is a sensitive part of the device.
- If you are not using the USB plug, keep it covered to protect from water, dust, etc..
- For manual read out, remove the USB cap and connect the plug to your computer.
- Do not apply force as it will damage the connector.
|
| Temperature |
- Temperatures outside the device operating temperature range may damage the device and/or reduce its performance. To learn about the device operating temperature range for each SmartMonitor type, see the information in the technical specification.
|
| X-rays/Röntgen |
- Avoid long-term exposure to X-rays/Röntgen (risk of damaging the device).
|
Subject to change. Please note that all information in this document is correct at the time of publication. Due to our policy of continuous product development, we reserve the right to change this information without prior notice.
On the back of the SmartMonitor device is a QR-code, which links the SmartMonitor User Manual.
For additional support, contact Berlinger support at support@berlinger.com.
Manufactured by:
![]() |
Berlinger & Co. AG
Mitteldorfstrasse 2
9608 Ganterschwil
SWITZERLAND |
Post your comment on this topic.