Operating routines – technical

From the NAVEKSA ShopFloor version 8.09.03 and newer, a change comprising asynchronous processing (Job queue processing) has been implemented in the ShopFloor application for performance reasons.

If you experience performance problems or data not being updated in ShopFloor planning or at the Operator terminal, you must check out the status in the following way.

Below you can read about handling Dynamics NAV. Further down about handling Business Central.

Operating procedures for Dynamics NAV:

Search for the term “job q” using the search bar in Dynamics NAV.

Make sure that the job “NAVEKSA SFSDLS clean up” is running

Every time the clean up job runs, a log file record is generated the stanard NAV way. This file must be cleaned manually at regular intervals.
F.ex. entries older than 7 days.

Operating procedures for 365 Business Central:

Search for the term “job q” using the search function.

Make sure that the job “NAVEKSA SFSDLS clean up” is running.
Make sure the job “NAVEKSA SFSPORL update” is running.

Every time the clean up job runs, a log file record is generated. This file must be cleaned manually at regular intervals.
F.ex. entries older than 7 days.

Feedback

Was this helpful?

Yes No
You indicated this topic was not helpful to you ...
Could you please leave a comment telling us why? Thank you!
Thanks for your feedback.

Post your comment on this topic.

Please do not use this for support questions.
NAVEKSA Help desk

Post Comment