READ button

The READ button is used to adjust the numbers. Each time you press the READ button, the number in the flashing digit will increase by 1. If you press READ more than necessary, continue pressing the READ button until you obtain the desired number.

Press READ to adjust the number

SET button

The SET button is used to save the number. After pressing the SET button, the next digit will start flashing.

Press SET to confirm.

Note: If SET is pressed mistakenly, continue with the setup instructions. The chapter Read and change settings / How to correct setting mistakes describes how to rectify the error.

Was this helpful?

Yes No
You indicated this topic was not helpful to you ...
Could you please leave a comment telling us why? Thank you!
Thanks for your feedback.