This topic will demonstrate how to configure a closure control condition and provide an example.

Closure controls can be configured for any rules whereby the rule relates to the objects within the BPEM/EMMA case category and where the object in the case has a one to one relationship with the attributes used for the rules e.g. If a billing outsort BPEM/EMMA case contains multiple billing document objects and the rule checks the status of the billing doc, standard configuration is not suitable for this rule. One BPEM/EMMA case must be created each billing document to enable standard configuration.

However, for unrelated rules or scenarios whereby you have multiple objects of the same type to be checked a BAdI is available to enable these rules to be set up.

Please see the Developers Cookbook for more information on the Closure Control BAdI:

Developers Cookbook


Was this helpful?

Yes No
You indicated this topic was not helpful to you ...
Could you please leave a comment telling us why? Thank you!
Thanks for your feedback.

Post your comment on this topic.

Please do not use this for support questions.
For customer support, please contact us here.

Post Comment