1. On the Route Selection screen, before you start navigating, you can add a waypoint by holding your finger down anywhere over the map until a grey pin appears.

2. Don’t let go and keep holding your finger down. Drag the grey pin to the position where you want the waypoint to be, and then you can stop holding your finger on the screen. The route will be adjusted to pass through that location.

3. By selecting them and dragging them around like you do with the waypoint, you can also change the starting point and the destination of your route (the start is marked with a green pin and a destination with a red pin).

Need more help with this?
Don’t hesitate to contact us here.

Was this helpful?

Yes No
You indicated this topic was not helpful to you ...
Could you please leave a comment telling us why? Thank you!
Thanks for your feedback.