7.1.3.3. ZPA Error and Information

There is an Error and Information area in the upper right corner in both the Upstream and Downstream Zone areas of the Main Screen. There is an indicator that shows if a Jam condition is active (either Arrival Jam or Sensor Jam). There is a numerical indicator of all occurrences of any Jam conditions since the last module power cycle. There is also a Clear button to allow you to clear a Sensor Jam if it is active.

*The Clear button is a convenience so you do not have to go the zone in question and remove or otherwise clear the item from the zone sensor. If Sensor Jam Auto Clear is enabled, clicking the Clear button will re-initiate this procedure.