PLC Developers Guide / ZPA Mode Control / PLC Outputs for ZPA Mode /
ConveyMerge Interface
Used to dynamically modify a ConveyMerge configuration already established with EasyRoll or EasyRoll+
ONLY AVAILABLE for FIRMWARE 4.25 and HIGHER
| Register Name | Internal Address | Assembled PLC Address |
Description | ||
| ConveyMerge Interface | 4:0387 | M: 4:1624 E: O.Data [24] P: Byte 48 (Hi) P: Byte 49 (Lo) |
Bitwise Value | ||
| bit 15 = | Set to enable PLC control of ConveyMerge | ||||
| bit 04 = | Set to disable release from Center Line | ||||
| bit 05 = | Set to disable release from Left Line | ||||
| bit 06 = | Set to disable release from Right Line | ||||
| Bits 0 thru 3 provide binary encoded value to allow the PLC to change the release priority* | |||||
*Change Release Priority Values
| Value. | Bit 3 | Bit 2 | Bit 1 | Bit 0 | Description |
| 0 | OFF | OFF | OFF | OFF | First come, first served |
| 1 | OFF | OFF | OFF | ON | Center Line has priority |
| 2 | OFF | OFF | ON | OFF | Left Line has priority |
| 3 | OFF | OFF | ON | ON | Right Line has priority |
| 4 | OFF | ON | OFF | OFF | Reserved |
| 5 | OFF | ON | OFF | ON | Reserved |
| 6 | OFF | ON | ON | OFF | Reserved |
| 7 | OFF | ON | ON | ON | Reserved |
| 8 | ON | OFF | OFF | OFF | Reserved |
| 9 | ON | OFF | OFF | ON | Reserved |
| 10 | ON | OFF | ON | OFF | Reserved |
| 11 | ON | OFF | ON | ON | Reserved |
| 12 | ON | ON | OFF | OFF | Reserved |
| 13 | ON | ON | OFF | ON | Reserved |
| 14 | ON | ON | ON | OFF | Reserved |
| 15 | ON | ON | ON | ON | Reserved |