1. Open Manual Mode and hold down the PUMP icon until all the liquid in the sediment tank is removed
    The Sediment Tank % will display 0% as shown above.


  1. Open front doors and lift up the shroud (highlighted in green above).
  1. Using a shop vacuum, vacuum up any foam or solids residue.


  1. If a complete clean is needed, remove the two thumbscrews from the doorstop in front of the sediment tank and remove the tank from the machine.
  1. Rinse the tank in a sink. Using hot water and a rag, clean the stainless steel sediment shroud and motor cover. Wipe down the inside of the RADOR.
  1. With the sediment tank removed, check the motor attachment fasteners
  1. Replace the tank, screw in the shroud and the doorstop.
  1. Reset Overall System maintenance hours by pressing the blue RESET button as shown below.
Screen Maintenance Hours

Yorum

Bu yardımcı oldu mu?

Evet Hayır
Bu konunun size yardımcı olmadığını belirttiniz ...
Bize neden olduğunu söyleyen bir yorum bırakır mısınız? Teşekkürler!
Yorumun için teşekkür ederim.

Bu konuyla ilgili geribildirimlerinizi gönderin.

Lütfen destek soruları icin bunu kullanmayın.
Your feedback will remain private. Click here to Request Technical Support.

Yorum Gönder