1. Using the scoop provided, scoop the media out into an empty bucket. A shop vacuum can be used for any remaining media.
  1. Using warm water and a sponge, wipe the inside of the tub and sheet metal.


  1. Using a thin pipe cleaner, clear out any debris inside the drain cap.
  1. Fill up the RADOR with new media.
  1. In AUTOMAT3D Mode, run a 2-hour media break-in cycle on AGA 1.

Yorum

Bu yardımcı oldu mu?

Evet Hayır
Bu konunun size yardımcı olmadığını belirttiniz ...
Bize neden olduğunu söyleyen bir yorum bırakır mısınız? Teşekkürler!
Yorumun için teşekkür ederim.

Bu konuyla ilgili geribildirimlerinizi gönderin.

Lütfen destek soruları icin bunu kullanmayın.
Your feedback will remain private. Click here to Request Technical Support.

Yorum Gönder