1. Open Manual Mode and hold down the PUMP icon until all the liquid in the sediment tank is removed
    The Sediment Tank % will display 0% as shown above.


  1. Open front doors and lift up the shroud (highlighted in green above).
  1. Using a shop vacuum, vacuum up any foam or solids residue.


  1. If a complete clean is needed, remove the two thumbscrews from the doorstop in front of the sediment tank and remove the tank from the machine.
  1. Rinse the tank in a sink. Using hot water and a rag, clean the stainless steel sediment shroud and motor cover. Wipe down the inside of the RADOR.
  1. With the sediment tank removed, check the motor attachment fasteners
  1. Replace the tank, screw in the shroud and the doorstop.
  1. Reset Overall System maintenance hours by pressing the blue RESET button as shown below.
Screen Maintenance Hours

Réaction

Était-ce utile?

Oui Non
Vous avez indiqué que ce sujet ne vous a pas été utile ...
Pouvez-vous SVP laisser un commentaire nous disant pourquoi? Merci!
Merci pour vos commentaires.

Laissez votre avis sur ce sujet.

SVP ne pas utiliser pour des questions de support technique.
Your feedback will remain private. Click here to Request Technical Support.

Valider