The RADOR is delivered with an industrial power cord. Use only the power cord supplied by PostProcess with the RADOR. Based on the model number of the machine, connect the RADOR only to the power indicated in the table below.

SF003 UL/CSA
North America
CE
MODEL -04 -06
PHASE 1 1
VOLTAGE 120VAC 230VAC
FREQUENCY 60 Hz 50 Hz
AMPERAGE 15A 16 A

Do not place the power cord in a location where it could come into contact with water or other liquid substances. It is recommended to keep the entire power cord suspended above the floor surface.

The RADOR utilizes power provided through an industrial power cable/connector located on the lower-left rear of the unit as highlighted in green below.

Power cord location
length of cord trimmed to fit image

The MASTER DISCONNECT SWITCH is located on the right access panel of the RADOR. Before connecting or disconnecting the RADOR to power, ensure the MASTER DISCONNECT SWITCH is in the horizontal “O” or OFF position.

When the power cord is connected to the RADOR and plugged into a specified power outlet, turn the POWER switch 90 degrees clockwise to the vertical “I” or ON position. The RADOR is now ready to be powered up.

The MASTER DISCONNECT SWITCH is located on the right access panel, shown above.
To turn OFF the MASTER DISCONNECT SWITCH, grasp the switch and rotate counter-clockwise 90˚ to OFF.

Réaction

Était-ce utile?

Oui Non
Vous avez indiqué que ce sujet ne vous a pas été utile ...
Pouvez-vous SVP laisser un commentaire nous disant pourquoi? Merci!
Merci pour vos commentaires.

Laissez votre avis sur ce sujet.

SVP ne pas utiliser pour des questions de support technique.
Your feedback will remain private. Click here to Request Technical Support.

Valider