Configure View

Use the following steps to configure a Lightning Conductor 2010 Web Part view.

1. From the Web Part menu of the LIghtning Conductor Web Part, click Configure view.
   
   
2. The Lightning Conductor 2010 Configuration Wizard dialog is displayed.

*Troubleshooting: If you cannot see the Configure view on the Web Part menu, the Enable View check box has not been selected in the Views section in Web Part tool pane. Ensure that you have click OK or Apply at the bottom of the Web Part tool pane once you have selected the check box.

← Create a View
Configuring the Lightning Conductor Web Part →