3.2. Ethernet Communications Configuration

To configure Ethernet (A22) Communications Adapters, select MENU > COMMUNICATION. The ATevo will display the adapters that may be configured.

To change settings for an adapter, do the following:

1. Navigate to it using UP and DOWN; select it with EDIT/ENTER.
2. Press UP and DOWN to navigate to parameter to configure.
3. Press EDIT/ENTER to select parameter.
4. For numbers, use LEFT and RIGHT to navigate to digit to edit, then UP and DOWN to change digit value, then EDIT/ENTER to store new value.
5. If options presented, use UP and DOWN to select, then EDIT/ ENTER to store new option.
   

As discussed in the Navigation section of the ATevo Operations Manual, all commands in this manual are also presented with a shorthand communication: Command > Command > Command, omitting navigation buttons like UP, LEFT, and ENTER.

To change or verify the ATevo Ethernet Communications Adapter Configuration:
MENU > COMMUNICATION > “Ethernet setup”

If “(none)” appears after “Ethernet setup” , the Ethernet adapter will need to be enabled according to instructions in Section 3.2.1.

*An Ethernet Communications Adapter (A22) is required for Ethernet communications to be operational. If one is not installed, the Ethernet configuration must be set to “disabled” (appears as “none”). See Section 2.2 for details on installing communications adapters.