Several Ethernet configuration parameters are used by all protocols; other parameters are used only by specific protocols. This section specifies configuration of parameters used by all protocols.
CLICK ON EACH TOGGLE (+) below for instructions.
- IP Address
- To change the IP address:
MENU > COMMUNICATION > “Ethernet setup” (as shown in Section 3.2) > “IP addr:” > change digits
![]()
- Netmask
- To change the “Netmask:” selection:
MENU > COMMUNICATION > “Ethernet setup” (as shown in Section 3.2) > “Netmask:” > change digits
![]()
- Gateway Address
- To change the “Gateway Address”:
MENU > COMMUNICATION > “Ethernet setup” (as shown in Section 3.2) > “Gateway:” > change digits
![]()
Last modified:
8 August 2022