Teka

Output

Zookeeper:

The Teka has a Single DP1.4 connector for use with Zookeeper. These use the motherboard on-board graphics system. This connector does not support Passive Adapters.

Max Resolution: 4096×2160 @ 60Hz
Supports Conversion to Analogue (VGA): No
Supports Display Port to DVI adaptor (passive): No
Supports Display Port to DVI adaptor (active): Yes

Production Output:

Base Model and Capture Configurations:
The Teka base model and Capture configuration has 2x DP1.4 connectors. The maximum output of Teka is a total combined Pixel Space of 4096×2400 Pixels.

Max Resolution: 4096×2160 @ 60Hz
Supports Splitters: Yes
Supports Conversion to Analogue (VGA): No
Supports Display Port to DVI adaptor (passive): No
Supports Display Port to DVI adaptor (active): Yes

GPU Configuration:
The Teka GPU configuration has 4x mDisplayPort 1.4a connectors. The maximum output of Teka GPU Configuration is a total combined Pixel Space of 4096×2400 Pixels.

Max Resolution: 4096×2160 @ 60Hz
Supports Splitters: Yes
Supports Conversion to Analogue (VGA): No
Supports Display Port to DVI adaptor (passive): No
Supports Display Port to DVI adaptor (active): Yes

EDID Emulation:

• AMD EDID Emulation
  

Status Screen:

Teka does not come equipped with a Front Panel Display.

Networking

Ports

Teka comes configured with two 1Gbps ports.

Power

Input

Connector: IEC (C14)
Power Consumption (Max): 600W

Output

Connector: n/a
Power Loopthrough (Max): n/a