Software Update

1) Remove Internet Cable from the box
2) Unplug and restart the box
3) Wait till it gets to “Page Loading Error”
4) Connect cable for internet back in
5) Select Embedded Portal, It will then update to version r10

If it dont start automatic update, press SET button on remote , then go to “software update”

Then press OK on remote and then F1 button

Additional advice can be found on the InfoMir Set Top Box software upgrades on the link below.
http://wiki.infomir.eu/doku.php/en:stb_webkit:faq:update_firmware_mag200_250