Configuring the Omega WiFi Amp with Rj45 Cable

Step 1. Plug the Omega WiFi Amp into an available wall socket and connect it to your PC/Laptop via included RJ45 network cable.

Step 2. Follow process A3 to A8 to configure your Wi-Fi Repeater

Step 3. Open the web browser and type http://192.168.10.1/, the default IP address in the address bar. Then press Enter to continue. For better compatibility, we recommend using a Microsoft browser.

*NOTE: The default IP address for this extender is http://192.168.10.1/

_**If you cannot load the management page on your browser, please hold the reset button for 5-8 seconds until all LED indicators re-flash, then remove the Omega WiFi Amp from the power socket and retry steps A1 to A3 again.

Step 4. Type the username and password into the appropriate spaces on the login page. The default username and password are both admin. Click Submit button to continue.

Step 5. After logging into the management page, please select the Repeater mode by clicking on the ‘Repeater’ button.

Step 6. Select your current wireless router SSID to continue.
*If you can not find your WiFi router, please refresh the page and try again.

Step 7. When you get the page below, please do NOT change the repeater SSID. Simply input your current WiFi security key and continue.

Click on the ‘Apply’ button. Wait for a few seconds as the Omega WiFi Amp restarts. Once the unit has turned back on, it is ready for use.

*We suggest that your current WiFi Security Key should not include strange symbols such as $ *& ^, as these might lead to a failed configuration. Characters and numbers are highly recommended.

Step 8. Wireless Repeater mode configure successfully!

*The default wireless SSID and security key is the same as your AP/router, after successful installation.

*The Management Page will be locked after your successful configuration. You CANNOT log into the management page via http://192.168.10.1. If you want to log into the Management Page again, please hold the ‘Reset’ button for 8-10 seconds to make all settings revert to Factory Default Settings. Once the unit has reset, reconfigure the Omega WiFi Amp again.