 |
The buttons on the right of the screen control access to basic navigation features.
|
There are four primary settings (below) that can be selected on the Auto Setup screen. The settings chosen for a specific cycle are based on the properties of the part(s) being finished as well as the type of fixture(s) being used for the cycle.
| Agitation Style & Lift Postion | Settings Basket Fixutre Mode And Lift Only that control the recommened energy level intensity. |
 |
Use caution when selecting this setting. Operating in the incorrect mode, unapproved baskets, or above the recommended setting can lead to detergent spillage. |
| TEMPERATURE | This is the temperature set point the system will maintain during operation. |
 |
Press and slide the blue Temperature button to the desired temperature or adjust with the plus and minus buttons. Note: The temperature shown in black at the top left of the page is the current tank temperature. |
| TIME | This setting determines the cycle run time. |
 |
Use the + and – buttons to increase or decrease the cycle time. |
| Pump Speed | This setting determines how fast the pump motor will run. |
 |
Use the + and – buttons to increase or decrease the pump speed. Depending on the selection of the Agitation Style the machine will provide recommended speed ranges that are safe with approved fixtures and baskets |
After adjusting the settings for the part to be finished, use the buttons shown below to control the cycle.
 |
Press PLAY to initiate or resume a cycle. |
 |
Press PAUSE to temporarily suspend processing while maintaining cycle time progress. |
 |
Press STOP to end processing and reset cycle time. |
Post your comment on this topic.