Consumables

!Only PostProcess approved consumables should be used in the DEMI 500 Series. Using third party consumables may void the warranty on the machine. Safety data sheets will be provided for all purchased consumables.

Detergent

	Wear safety glasses or goggles. Use eye protection equipment that has been tested and approved by recognized national standards (or equivalent).
	When working with or near detergents, use disposable Nitrile gloves of at least 5 mil (0.005”) thickness. Change gloves after each use.

All detergents will be shipped from PostProcess in 5-gallon (18.9 L) jerrycans or 55-gallon (208.2 L) drums and poured into the DEMI 500 Series by hand or pumped into the machine using a suitable chemical transfer pump.

PLM-403-SUB
Typically used for removal of uncured Stereolithography (SLA) resin. Refer to the SDS for more information.

PLM-501-SUB
Typically used for removal of uncured Elastomeric Stereolithography (SLA) resin. Refer to the SDS for more information.

PLM-601-SUB
Typically used for removal of wax and similar support material. Refer to the SDS for more information.

Handling and Disposal

The DEMI 500 Series features a removable stainless steel basket with handles for part handling. Plumbing for the DEMI 500 Series is internal to the machine and self-contained with the exception of the drain valve. The drain valves have barbs for any chemically-compatible flexible tubing with a 1” / 25.4 mm diameter. Suggested materials: PTFE, HDPE/UHMW, Nylon, FEP. Always dispose of used detergent in an approved hazardous material receptacle. Follow local, state and federal guidelines for disposal.