The DEMI 500 Series is designed to be fully automatic and configured to remove supports or resin from the following 3D print technologies: SLA, CLIP, and others. The DEMI 500 Series is engineered to utilize an automated submersion system that is configurable based on a specific operational need. To learn more, please contact PostProcess and ask about the DEMI 500 Series Configuration Settings.
The top side of the DEMI 500 Series houses the main processing tank. The envelope is approximately 35.5cm x 35.5cm x 35.5cm (14” x 14” x 14”) and is filled with detergent carefully selected to maximize a specific support removal need. Caution should be used when reaching into the tank.
For more information about cleaning and maintaining the filtration system for the DEMI 500 Series, please see the Maintenance Operations section of this User Manual.
To begin a cycle, if the controller touchscreen is off, press the POWER button to turn ON the DEMI 500 Series and wait for the Main Menu screen to display (as shown below).
 |
| Home screen |
The Auto Setup screen (below) can be accessed by pressing the AUTOMAT3D button from the Home screen. It is important to note that the DEMI 500 Series will retain the settings from the previous cycle. If no changes are required, the cycle can be started by pressing the PLAY button. If new settings are required for the next cycle, review the procedures in the Auto Setup Controls section.
 |
| Auto Setup screen |
Post your comment on this topic.