Automatic Operation – Setup/Start

The BASE is designed to be fully automatic and configured to remove powder from the following 3D print technologies: SLS, MJF, and smooth surfaces for SLA, CLIP, DLP, various metals, and others. The BASE is engineered to utilize an automated system that is configurable based on a specific operational need. To learn more, please refer to BASE Configuration Settings.

The front of the BASE has an access door which houses the part chamber. The part envelope is roughly 45.7cm x 45.7cm x 45.7cm (18” x 18” x 18”)” where the part is exposed to a combination of chemical detergent and suspended solids that are carefully selected to optimize a specific post-printing need. The chamber door is hinged and weighted to stay open when opened, yet caution should be used when reaching into the chamber.

Behind the right panel door is where the operator can access to the filtration system. For more information about cleaning and maintaining the filtration system for the BASE, please see the Maintenance Operations section of this User Manual.

!Whenever an operator is handling detergents, nitrile gloves and eye protection should be worn.

To begin a cycle, press the POWER button to ON and wait for the Main Menu screen to display (as shown below).

Main Menu

The Auto Setup screen (below) can be accessed by pressing the AUTOMAT3D™ from the Home screen. It is important to note that the BASE will retain the settings from the previous cycle. If no changes are required, the cycle can be started by pressing the PLAY button. If new settings are required for the next cycle, review the procedures in the Auto Setup Controls section.