Alarm & Warning Conditions

TYPE	DESCRIPTION	HOW TO RESOLVE
WARNING	Tank Not Full	Add detergent to processing tank using the DOSE function explain in Manual Operations.
WARNING	Auto PSI Low	Spray valve pressure begins to fall below the desired pressure setting. This is an indication that the drain and filters need to be cleaned. See Filter Maintenance
WARNING	Auto PSI High	Spray valve pressure begins to rise above the desired pressure setting. This is an indication that the spray valves need to be cleaned. ▶
WARNING	Low pH Level	The pH balance in the tank has gone below the desired pH setting. It is typically cleared by running a dosing cycle.
WARNING	Temperature Limit Exceeded	The temperature has gone over the setpoint limit. While active, no device that adds heat to the system can be turned on. This warning will clear once the tank temperature falls below the temperature limit.

TYPE	DESCRIPTION	HOW TO RESOLVE
ALARM	Low Tank Level	See Low Tank Level for more detail.
ALARM	Emergency Stop	Confirm operating conditions are safe. Pull out e-stop button to reset.
ALARM	Over Temperature	See Over Temperature for more detail.
ALARM	Chamber Door Open	See Chamber Door Open for more detail.
ALARM	Filter Screen Maintenance Due	The Remaining Optimal Usage Gauge has expired. See Maintenance Mode Settings for more detail.
ALARM	pH Sensor Maintenance Due	The Remaining Optimal Usage Gauge has expired. See Maintenance Mode Settings for more detail.
ALARM	Dosatron Maintenance Due	The Remaining Optimal Usage Gauge has expired. See Maintenance Mode Settings for more detail.
ALARM	PSI Extreme High	Valve pressure has risen above the high tolerance set point. Check the spray valves for residue buildup. See Troubleshooting.
ALARM	PSI Extreme Low	Valve pressure has fallen below the low tolerance set point. Check the tank drain and screen for buildup. See Troubleshooting.
ALARM	Dosing Error	See Dosing Error for more detail.
ALARM	Motion Error	See Motion Error for more detail.
ALARM	Defoamer Required	See Defoamer Required for more detail.
ALARM	HMI Comm Error	The controller touchscreen or PLC stopped communicating with one another. To resolve, a system restart may be necessary.

Feedback