When the SETTINGS button is pressed, the user has access to basic operational functions as described below.
 |
| Enabling Settings |
Auto-Temperature – Heat is an important component of post-processing. The BASE has functionality built-in to allow the detergent to be maintained at a certain temperature when the machine is not in use. The AUTO-TEMPERATURE setting should be enabled if the tank needs to be kept at a constant temperature between cycles. If AUTO-TEMPERATURE is not enabled, the BASE tank heater will need to be run manually to bring the temperature up to the desired level before starting the cycle.
Auto-Level – When enabled, the tank level will be monitored at a user-defined interval. If the tank level drops below a predefined level the tank will be automatically dosed back to 100%. A message will appear to inform the user.
Auto-Drain – When enabled, the tank will automatically drain after the completion of a user-defined amount of autocycles.
Auto-pH – When enabled, the tank’s pH will be monitored. If the pH falls below the Minimum Operational pH Level a warning will become active and the tank will be automatically drained and re-dosed to correct the pH level. A message will appear to inform the user.
Advanced Output – When enabled, additional sensor data will be displayed in red throughout various screens. This mode is used for debugging.
Light Stack Test – When pressed, the light stack will illuminate so the user can verify that the lights are operational. The light stack should be tested at the beginning of each shift.
Post your comment on this topic.