BASE

10 of 11: 2 Hour Systems Check

  • Run the system in AUTOMAT3D mode, on AGA 4 with the correct processing temperatures (100-110F for PolyJet, 130-150F FDM).
  • While the cycle is running, look over all plumbing and outside for any visible leakage.

Feedback

Was this helpful?

Yes No
You indicated this topic was not helpful to you ...
Could you please leave a comment telling us why? Thank you!
Thanks for your feedback.

Post your comment on this topic.

Please do not use this for support questions.
Your feedback will remain private. Click here to Request Technical Support.

Post Comment