Advertisim

Vertical MPD Screen

INSTALLATION OF SCREEN:


STEP 1

1.1 With the screen removed from the stand, disconnect all cables.



1.2 Cables removed in the previous step.



1.3 Remove the support with the speaker using the hexagonal wrench and disconnect the cable.



1.4 Remove the indicated nuts to remove the electronic boards.



1.5 Remove the nuts with the hexagonal wrench to remove the support. Remove all the nylon sleeves.



1.6 Remove the support by pulling on the hinges.



1.7 Pull the LCD panel upwards from one end to remove it.


STEP 2

2.1 Peel off the glass with the spatula.



2.2 Remove the adhesive with the scraper provided. It is recommended to use acetone or solvent to facilitate this step. Use the spatula for any difficult residue.



2.3 Remove the protective tape from the glass.



2.4 Stick the new glass to the frame, ensuring it is centered. Apply pressure on the glass for proper adhesion.


STEP 3

3.1 Clean the glass and install the frame with an outer top notch in the center. Install the TFT panel by removing the protective plastic. Use the hole positions as reference.



3.2 Install the frame with two outer notches in the center. This fixes the TFT panel onto the screen.



3.3 Hold the support using 3 small nylon sleeves removed earlier and a hexagonal nut from the kit. Install the LVDS cable into the TFT panel.



3.4 The LVDS cable connection with the TFT panel should be done in the same way as shown in the image.




3.5 Install the electronics support, passing the LVDS cable through the central hole. The LVDS cable should not be detached from the panel.



3.6 Secure the support with the 4 nuts that were removed earlier. It is necessary to use the 5.5mm hexagonal wrench.


STEP 4

4.1 Install the 4 medium-sized nylon sleeves removed earlier. This will allow raising the video controller support.



4.2 Install the support provided with the kit, passing the LVDS cable underneath. It is secured with 4 nuts using the 5.5mm hexagonal wrench.



4.3 Install the video controller, using the 4 screws provided in the kit. A flat screwdriver is required.



4.4 Connect the LVDS cable to the video controller. Center the red dot with the pin 1, marked on the board. The white connector enters in a unique position on the board.


STEP 5

5.1 We will connect the following cables from the TCU located on the cabin ceiling to the TFT controller:

· HDMI cable.
· 12VDC power cable (Out)

Connection guides for control system for TCU: