The initial linkage creation and ongoing linkage creation are done in each Development system via the following program: /BTI/TE_RLINKS_UPDATE_JOB_V2
This is covered by the prerequisite steps in the previous MDR section so are not duplicated here.
Basis Technologies
-
ActiveControl - Administration Guide — 6.10
- ActiveControl - Administration Guide — 9.30
- ActiveControl - Administration Guide — 9.20
- ActiveControl - Administration Guide — 9.10
- ActiveControl - Administration Guide — 9.00
- ActiveControl - Administration Guide — 8.50
- ActiveControl - Administration Guide — 8.40
- ActiveControl - Administration Guide — 8.3
- ActiveControl - Administration Guide — 8.2
- ActiveControl - Administration Guide — 8.0
Post your comment on this topic.