4.2.2 Directory Rules

Directory Rules provide presence status to directory numbers that do not match the extension in Cisco Communications Manager.

For example, a user’s telephone number in the directory may be the full E.164, but the actual extension in CUCM could be a shortened 5 digit extension. Directory Rules can be used to map the directory number to the extension to provide valid presence status.

Note: This step is optional. If you do not need to configure Directory Rules or would like to do so at a later time, click Cancel.

Please Refer to the Dial Rules Configuration section to review fields associated with creating Directory Rules in Akkadian Console.

To add a new Directory Rule:

1. Click the icon and go to Options.
2. Enter the Configuration Password
3. Select Directory Rules
4. Fill out all required fields (E.164 to 5 digit conversion shown)
   
5. Click Add and test the Directory Rule with a sample number. The Input Length and Digit Count should match the Length stated in the Rule Criteria
6. Click Save
7. Click OK to confirm changes or Cancel to close
   

Copyright and Trademarks:

I. Copyright:

This website and its content is copyright © 2018 Akkadian, LLC. All rights reserved. Except with the prior written permission of Akkadian, LLC, any redistribution or reproduction of part or all of the contents of this website, including the redistribution or reproduction of any documentation or other materials downloaded from this website, in any form and in any media, is prohibited.

II. Trademarks:
Akkadian, the Akkadian logo and other trademark or service marks used on this website, whether registered or not, are the property of Akkadian, LLC and may not be used or reproduced without the prior written permission of Akkadian, LLC.

aPME UG 1/8/2018 0001 © http://www.akkadianlabs.com/apme/