ZPA/Reduced ZPA Modes

General

	There is no equivalent setting in EasyRoll because these are determined by the Auto-Configuration procedure
	Set up for master/slave motor rollers in a belted zone. There is no equivalent setting in EasyRoll
	Sensor Debounce setting
	Enable/Disable FlexZone operation
	Change Upstream ConveyLinx Connection. If you want to perform the EasyRoll equivalent of selecting “None” for the connection, select the drop down option “Connect the the module with the below IP address” and enter “0” for each IP address octet.
	Change Downstream ConveyLinx Connection. If you want to perform the EasyRoll equivalent of selecting “None” for the connection, select the drop down option “Connect the the module with the below IP address” and enter “0” for each IP address octet.