ConveyLinx-Ai2-48

Regardless of the specific **, each is equipped with the ability to separate the MDR Power from the Logic Power.

!Please note that in all power connection situations it is recommended to tie all DC common terminals together and a single connection to earth ground.

*Please note that ConveyLinx-Ai2-48 Sensor and I/O ports accommodate 24V devices even when powered by 48V power supplies.
You can still use your typical 24V sensors and I/O devices.

Connecting only MDR Power

*Connecting only to MDR Power will provide power to both the motor circuits and the logic circuits.

The diagram shows the Power Terminal connections for 8 total modules separated into two groups of 4 modules powered by 2 separate power supplies.

Connecting only Switched MDR Power

These diagrams depict the same examples shown above with the exception of the power supplies being included in an externally controlled switching circuit such as would be used for an E-Stop.

Connecting Separate Logic and Switched MDR Power

*Providing a separate power connection to the Logic Power, you can keep the logic and communications powered and active and disconnect the MDR Power to assure all motors are disconnected such as in an E-Stop situation

The diagram shows the connection for when Logic Power is coming from a separate power supply than the MDR Power. Please note that the Logic Power supply is connected to the Logic terminals for all 8 modules.