Pulseroller Products / Washdown Idler Rollers
| General Specifications | Washdown Idler | NSF Washdown Idler |
| Available Tube Diameters | 48.6 mm (1.9”) 50 mm (1.97”) |
|
| Minimum Tube Length | 200 mm (8”) | |
| Maximum Tube Length | 1000 mm (39”) | 800 mm (31”) |
| Tube Material | Stainless Steel – SUS304 | |
| Bearings & Shaft Materials | Stainless Steel – SUS303 | |
| Ingress Protection | IP66 (Model W) IP69K (Model Q) |
IP66 |
| O-Rings & Seals Material | Nitrile (Model W) Viton (Model Q) |
Nitrile |
| Ambient Temperature | -10 ~ 40º C (14 ~ 104º F) | |
| Ambient Humidity | 10 ~ 90 RH (No Condensation) | |
Part Number Definition for Pulseroller Washdown Non-Powered Idler Rollers
| ① | ② | ③ | ④ | |||||||||||||||
| F | R | – | W | 0 | – | 4 8 | – | 5 0 0 | – | A | S | G | Q | |||||
| PULSEROLLER Family |
Model | Roller Diameter | Roller Length | ↑ | ||||||||||||||
| Interlock Options | ||||||||||||||||||
| ① Model | ||||||||||||||||||
| W – Washdown Rated (IP66 w/ NBR seals) | V – NDF Certified Washdown (IP66 w/ NBR seals) | |||||||||||||||||
| Q – Enhanced Washdown (IP69K w/ Viton seals) | ||||||||||||||||||
| ② Roller Diameter | ||||||||||||||||||
| 48 – 48.6 mm (1.9”) | 50 – 50 mm (1.97”) | |||||||||||||||||
| ③ Roller Length (mm) – Available in 1 mm increments | ||||||||||||||||||
| Formulas for Roller Length (RL) based upon Between Frame (BF) dimension for proper clearance | ||||||||||||||||||
| For Interlocking Options A and G : RL = BF – 8 mm – Customer Required Clearance | ||||||||||||||||||
| For Interlocking Options H: RL = BF – 35 mm – Customer Required Clearance | ||||||||||||||||||
| For most conveyor applications, Customer Required Clearance = 2 mm | ||||||||||||||||||
| ④ Interlocking Options | ||||||||||||||||||
| A – Plain Straight (No Interlocking) | G – Round Grooves | |||||||||||||||||
| H – Micro-V Hub (Not available for Model V) | ||||||||||||||||||
| Please note that not all combinations of options result in a valid part number. Contact Pulseroller for details | ||||||||||||||||||