Power and Electrical
The following is required from the customer:
SR009 | CE | UL/CSA |
---|---|---|
MODEL | -08 | -07 |
Power | 1 PH, 230VAC, 15A | 1 PH, 120VAC, 15A |
Receptacle |
CEE 7/3 Socket |
NEMA 5-15R Standard |
Facility and Floor Requirements
Operating Environment Requirements:
- Temperature: 15°C to 27°C (60°F to 80°F)
- Relative humidity: 0% to 80%.
- Maximum altitude: 10,000 feet (3,048 meters)
- Pollution Degree 2
- Overvoltage Category II
- Sufficiently sized doorways to transport the machine from loading dock to permanent installation location.
- Smooth, level flooring. The DEMI 400 Series must be placed on a level floor.
- Sufficient space in installation location for DEMI 400 Series and operator to maneuver around the machine and access master disconnect switch during normal operation.
- Locate and operate the unit at least 6 inches (0.15m) from any wall from all enclosure sides
- Installation area should be spacious and well ventilated.
- Power disconnects, plumbing, and emergency equipment should be installed in the same room as the DEMI 400 Series.
Ventilation
PostProcess Technologies detergents are specifically formulated chemistry for maximized 3D printed support removal efficiency. Specific ventilation requirements can vary widely due to the local, state, and federal regulations, size of the install room, and existing ventilation (positive or negative).
To meet safety and environmental requirements, our solutions should be located in a well ventilated area, have a ventilation draw, and it is recommended that the post printing operations using PostProcess equipment and chemistry solutions have ventilation that is exhausted externally. Make up air should be provided from the facility where the equipment is located.
It is recommended that customers performing post printing operations have or consult with a responsible environmental health and safety person (such as an Industrial Hygienist) to determine and verify meeting environmental, health, and safety (EH&S) requirements.
PostProcess can provide the recommended ventilation requirements for each of our solutions as well as recommendations for ventilations consultation and EH&S / Industrial Hygienists.
Post your comment on this topic.