The DEMI 400 Series is delivered with an industrial power cord. Use only the power cord supplied by PostProcess with the DEMI 400 Series. Based on the model number of the machine, connect the DEMI 400 Series only to the power indicated in the table below.
| SR009 | UL/CSA | CE |
|---|---|---|
| MODEL | -07 | -08 |
| PHASE | 1 | 1 |
| VOLTAGE | 120VAC | 230VAC |
| FREQUENCY | 60 Hz | 50 Hz |
| AMPERAGE | 15A | 15A |
Do not place the power cord in a location where it could come into contact with water or other liquid substances. It is recommended to keep the entire power cord suspended above the floor surface. The DEMI 400 Series utilizes power provided through a 2M (6.6ft) industrial power cable/connector located on the lower right section of the rear of the machine, attached to the controls enclosure, as shown in the image below.
 |
| Power cord location |
The MASTER DISCONNECT SWITCH is located on the front door of the controls exclosure on the right side of the DEMI 400 Series. Before connecting or disconnecting the DEMI 400 Series to power, ensure the MASTER DISCONNECT SWITCH is in the horizontal “O” or OFF position.
When the power cord is connected to the DEMI 400 Series and plugged into a specified power outlet, turn the MASTER DISCONNECT switch 90 degrees clockwise to the vertical “I” or ON position. The DEMI 400 Series is now ready to be powered up.
Post your comment on this topic.