Volume Control

VOLUME CONTROL

Inspect for general condition, nothing loose, broken, torn or missing.
If it is not operational:

• Check the solder connections at the terminals on the pot to determine that there is no break in connections.
• Check the male/female plastic wire plug connection to determine that there is no break in connection.
• If no issues are found, replace the volume control assembly.

• Unplug wire connection.
• Remove volume control knob from the stem with an Allen Key.
• Loosen retaining nut on the post.
• Remove spacer, washer and volume control assembly.
• Re-install new volume control assembly, replug the wire connection and install knob.